Do you have clay as your soil base?
Do you have a high water table?
Do you just have water issues?

Water takes the path of least resistance and will essentially find any gap around your pool to fill into.  If you have a high water table or a soil base that doesn’t allow water to run through it easily, you can get what is called a “floating liner”.  When the ground water pressure is more than the water pressure inside the pool, it essentially pushes the liner off the vermiculite bottom.

The pool water in the pool didn’t have enough pressure to hold back the ground water.  While this can happen to anyone that doesn’t have enough water in the pool, it can also happen when your pool is completely full of » Continue reading “Sump Systems – The Correct Way to Prevent a Floating Vinyl Liner (video)”

Seems easy enough to most pool owners, but for new owners it might be a little confusing.  Maybe confusing is the wrong word, maybe new pool owners aren’t patient enough.

A self-priming pump, by definition, is a pump which will clear its passages of air if it becomes air bound and resume delivery of the pumpage without outside attention.

If you are firing up the pump for the first time on your new inground swimming pool or if you are just opening your pool for the year, you will have to prime your pool pump.

1. Make sure your pump is turned off and slowly open the lid of the pump.  The lid to the pump is more than likely clear.  Opening the pump lid slowly is important as it is more than likely under pressure.  When you open it, you will hear the air “hiss” out.
2. Make sure there is no debris or “stuff” in the basket of the pool pump, if there is remove it.  If you pump is old and the basket is starting to break or fall apart, REPLACE IT.  A broken pump basket will allow debris to get to the impeller of the pump . . . not a good thing.
3. If you have multiple suction lines (skimmers, main drains) close them all off but one.  I prefer to close all the valves except the main drain as the main drain will have less air in it than a skimmer line.  Now get a bucket of water (2-3 gallons) or a hose to fill up the pump with water.  The water will go into the pump and fill up going back down the plumbing line that has been left over. » Continue reading “How to Prime Your Swimming Pool Pump?”

Why do pool builders always skimp or rush through the plumbing?  If it is done wrong or looks like junk, no one will be happy.
Straight lines and having everything symmetric is always more appealing to the eyes, but not always possible.  Excessive use of 90 degree elbows will hinder water movement and add a lot of friction loss.

Penguin Pools builds and designs pools to meet Federal Guidelines for flow, turnover rate, entrapment protection, and placement of returns.  Differences in plumbing setups and equipment sizing will affect water clarity, chemical usage, and overall operating costs from month to month.

Lets try to make this simple.

• As water moves through pipes it creates friction, slowing it down . . . just like the air against your car as you drive down the road.
• Each 45 degree elbow slows the water down a little and even more so with a 90 degree elbow . . . just like taking a turn in your car.
• You can go faster down a straight road, but must slow down at a bend & even slower for a corner.

Each time the water slows down due to friction or an elbow, the less water you are moving though your filter and sanitation system.

Pools without variable speeds pumps should have their water turn over once (1 time) every 6 hours !!!

If something looks wrong, SAY SOMETHING.

There is no way this plumber or pool company got paid, how do you even think to plumb something » Continue reading “Swimming Pool Plumbing”